How can you protect streams and riparian habitat if you don’t know where they are?

Western Washington has a vast stream network. About one third —or 476,000 acres—of DNR-managed state trust forests are within protected riparian (streamside) areas that offer important habitat for native plants, fish and animals. Locating these streams helps DNR conserve valuable streamside habitat when designing timber sales. To help find and protect these streams and their habitat, a DNR research team is using LiDAR (Light Detection & Ranging) 3-dimensional technology to create maps of stream systems.
DNR’s habitat commitments
Under DNR’s habitat commitments, trees in streamside forests only can be harvested for habitat enhancement projects—95 percent of riparian forests are left unmanaged so trees just grow, die, fall, grow again in a rich forest tapestry. Over time, they are becoming old forest, boosting the amount of this valuable complex forest structure that so many species depend on.
Streamside forest buffers on trust lands vary in width between 100 feet and 200 feet on each side of the stream — the width protected depends on whether there are fish in the stream and on the dominant trees’ maximum height. So these permanent protected forest swaths are from 200 up to 400 feet wide…. more than a football field.

LiDAR helps DNR find the streams
With small, headwater tributary streams hard to find, especially in dense forests, DNR turns to LiDAR technology to gather information about the landscape.
LiDAR uses an aircraft-mounted scanning laser to map ground features. The light from the laser is projected onto the ground surface, and the reflections from treetops, tiny pebbles and everything in between, are used to construct an extremely accurate, high-resolution map of the terrain. Mathematical models then are used to predict how and where water would flow across the terrain surface.

New technology, higher accuracy, better habitat protection
DNR has mapped streams for years to help define streamside habitat to be off limits during timber harvests. But not all maps—or mapping technology for that matter—are equal. LiDAR can locate previously unmapped stream channels, and accuracy is typically within 3 meters, versus the 10-to -12 meter error margin of older technology. More accurate maps help foresters identify riparian habitat more quickly so they can meet the agency’s objectives to conserve and restore riparian habitat.
Importantly, LiDAR maps can help DNR to prioritize areas for riparian protection. Many small, seasonally dry headwater stream channels have gone unnoticed until now. By knowing where they are, foresters can conserve trees where they are important, though not necessarily required.
From pilot project in Whatcom, Skagit and Snohomish Counties to forests across the state
As a pilot project using these techniques, streams in state trust forests in DNR’s Northwest Region were completely mapped, and foresters now can use LiDAR-derived maps as a screening tool to protect riparian forests as they design a timber sale. Feedback has been overwhelmingly positive. Ultimately, DNR’s research team hopes to map all of Washington, which will enable conservation of valuable habitat along large and small streams throughout the state.
Trust Lands Habitat Conservation Plan for forested state trust lands in the range of the northern spotted owl—western Washington and on the eastern slopes of the Cascade Mountain Range.
| Follow DNR on: | ![]() |
![]() |
![]() |
![]() |
![]() |
|





